An Armaguard bedliner becomes an integral part of a truck. There are no screws, drilled holes or clamps to come loose. Our durable liner is sprayed on forming an air and watertight layer of protection between the elements and the truck bed to permanently prevent rust and corrosion. Uses for Armaguard products are as diverse and numerous as your imagination.

How we do it

1. The bed is wiped down with wax and grease remover to clean any substances that may stop the liner from adhering.

2. The tailgate and hardware such as tie downs and tailgate bolts are removed (where possible).

3. A special "wire cutting" tape is applied to all edges where the liner will be trimmed.

4. Paper and plastic film are used to mask all areas of the truck that are not to be sprayed.

5. All surfaces to be sprayed are power sanded to ensure permanent adhesion.

6. The edges are hand sanded to avoid damaging the paint beyond the liner.

7. All the dust from sanding is blown off the bed.

8. The liner is sprayed into the bed and onto the tailgate by a trained applicator.

9. The liner is thoroughly inspected before the masking is removed.

10. The edge wires are pulled up through the coating to produce clean edges.

11. The rest of the masking is removed.

12. All hardware and the tailgate are re-installed.


For more information or to schedule an appointment call:

Ben Davey 
705 575 2753
Rick Ardito 
705 256 7481

or, you can get in touch through Facebook!